Enter new speed or load for a route measurement point

Overview

If the equipment is running at a different speed or load than specified in the route, you can override the speed in the route. Change the speed to ensure you collect accurate data.

You can use a tachometer or CSI 430 SpeedVue Sensor to input the RPM.

Note: If the measurement point is set up for FPM, you are prompted to enter the FPM value rather than the RPM.

Procedure

  1. Activate a route.
  2. From the Route Data Collection screen, press ALT > F6 New RPM.
  3. Enter a new load value between 0 and 900,000, and press Enter.
  4. Press F10 Manual Speed Entry.
  5. Enter a new RPM value between 0 and 100,000, and press Enter.