CSI 555 Mobile Procedures

• FAQ for this site
• Adjust the phase delay
• Balancing and phase measurement setup guidelines
• Change the flash rate
• Charge the battery
• Collect balance and phase measurement data
• Connect to the CSI vibration analyzer
• Enable or disable filter tracking
• Enable or disable External Delay mode
• Enable Lock mode
• Enable Tachometer mode
• Internal mode - TACH frequency generator
• Open the main menu options
• Replace the lamp
• Remove and dispose of the battery
• Restore the factory presets
• Select a flash rate from a preset
• Set up a phase analysis
• Store the current flash rate in a preset
• Test the movement of a mechanical support or a piping system
• Turn on the CSI 555 strobe
• View the software revision and current settings

CSI 555 Procedures

Keywords:

• ACCEL
• analyzer, connect to
• ANALZ
• balance and phase data
• balance and phase data
• battery, charge
• battery, remove and dispose
• BLANK
• BLITE
• collect balance and phase data
• CSI 555, main menu
• CSI 555, turn on strobe
• DECPT
• External Delay mode
• factory presets
• filter tracking
• flash rate, change
• flash rate, select from preset
• flash rate, store in a preset
• INPUT
• Internal mode
• lamp
• Lock mode
• main menu
• mechanical support, test movement
• motion studies
• OUTPT
• phase analysis
• Phase Delay, adjust
• piping system, test movement
• power on strobe
• replace the lamp
• restore factory presets
• software revision
• tach frequency generator
• Tachometer mode
• TTL pulses
• tuning knob, change flash rate
• turn on strobe
• vibration analyzer, connect to
• view software revision
• x2 key