The following fast key sequences assume that you are using a Rev 4 DD. Press Send to save the changes to the device.
| Key sequence | Menu items |
|---|---|
| 2, 2, 1
(Manual Setup) |
Network ID Broadcast Info Join Device to Network Configure Publishing Configure Update Rate Transmit Power Level Default Burst Config |
| 2, 1
(Guided Setup) |
Configure Sensors Configure Variable Mapping Configure Units Alert Limits Sensor Power Enable Join Device to Network Configure Publishing Configure Update Rate |
| Function | Key sequence | Menu items |
|---|---|---|
| General settings | 2, 2, 3 (Manual Setup) |
LCD Mode Power Source Advanced Config Units Write Protect MHM Access Control |
| Alert setup | 2, 3 |
Overall Velocity PeakVue Bias Ambient Temperature Supply Voltage |
| Update rate |
2, 1, 8 (Guided Setup) 2, 2, 1, 5 (Manual Setup) |
Configure Update Rate |
| Publishing mode |
2, 1, 7 (Guided Setup) 2, 2, 1, 4 (Manual Setup) |
Configure Publishing |
| Write protect |
2, 2, 3, 5 (Manual Setup) |
Write Protect |
| Power options | 2, 2, 3, 2 (Manual Setup) |
Power Source |
| MHM Access Control | 2, 2, 3, 6 (Manual Setup) | MHM Access Control |
| Supply power to sensor | 2, 1, 5 (Guided Setup) | Sensor Power Enable |
| Configure variable mapping | 2, 1, 2 (Guided Setup) | Configure Variable Mapping |
| Device reset | 3, 6, 5 |
Device Reset Restore Factory Default Settings |